They suggested contacting schlage which is a joke.
Schlage connect door lock wont connect to wink hub.
When you have successfully connected your devices you will see a flashing green check mark on the lock.
The lock should now be ready to go for manual usage.
They have yet to suggest anything to try.
I cannot set up the house lock and hub.
In the new app click your hub from your dashboard.
Bmott0817 april 24 2020 8 17pm 1.
This allows you to communicate with your lock via the wink app when you are remote.
List of products included in this video.
From there enter in one of the user codes.
I tried moving my schlage lock from my wink hub over to my hubitat.
Use amazon alexa to control your lock with your voice.
The keypad should light up.
My app only shows one lock.
Start by opening up the door keeping it unlocked and press on the schlage button at the top of the keypad.
Then run the pairing command on your lock.
And you may be able to completely unpair your lock which allows the lock to be paired again with your hub.
When used with your z wave compatible smart home automation hub alexa connects to your schlage connect smart deadbolt so you can lock your door and check whether or not you locked up before you went to bed by just asking.
Congratulations you are connected to your schlage touchscreen deadbolt.
I tried several more times and no luck.
The lock will blink an orange light for a few seconds then you will get a green check mark on the lock as well as a green flash of light on your wink hub wink hub 2.
None of the 3 locks will connect.
I have reset the locks the hub is within a foot when i try to pair i have a zwave device 3 feet away that is paired new batteries in the locks uninstalled and reinstalled the new st app tried with new and old st app excluded get notification on app it worked and lock shows green check included lock.
Schlage lock won t connect to hubitat or wink.
In the top right hand corner there s 3 dots click that and choose z wave exclusion.
To sync your schlage connect smart deadbolt with z wave plus to your wink hub open the wink app on your mobile device and follow the app s instructions.
It began to initialize and then got stuck and never finished.
The wink app will also indicate that it has found the lock.
I went and replaced the lock thinking something went wrong with it but after installing a new lock it still wont connect.
Make sure the wink hub wink hub 2 is blinking a blue light then press the 0 button on your lock.
I talked to wink and went through troubleshooting to no luck.
Get instant notifications whenever the door is unlocked.
I ran a exclusion and it did pick up the lock and removed the unknown device.
